Search results

Found the bad lifter!

Ya it sucks but it is what it is. It will be right this time and should never have the problem again. They are deleting the MDS while they are in there so it’s actually better in the long run.

It’s really not hard just have to take your time and trust that you can do the job. I could have done the motor swap myself just ran out of time and had to go back to work for the season.

Ok so a little update. My jeep was completely done and they went out to take it for a test drive and anything over 3500 RPM’s it would have a horrible misfire in cylinder 5. Long store short it has a bad cam and lifter. I have paperwork saying the motor has under 5k miles. The guy I bought it...

Welcome to the family!

Welcome to the family!

Welcome to the family!

Not sure there is any whiskey left anywhere in the western United States lol. Looks like a good time sucks I couldn’t make it!

I bet it’s a ground issue also. I had this same issue with my 392 and it ended up frying my alternator. Check the one one the frame right behind the passenger front tire. My bolts were tight and everything. The bolt wasn’t threaded enough and couldn’t tighten down enough to make ground tight. I...

I’m in!!

Also had some EVO air bumps installed on the rear

Another video without the exhaust leak

It’s running!! Has a little exhaust leak but still sounds amazing!!!

You should have bought mine bro!!!

I was there when you made the deal.

Ya I no. I didn’t want metalclaok lol but that’s what they got.

They have been waiting for a new crossmember for over a week now. They finally got it today so he was able to bolt it up and get the tranny all bolted up as well. He has only the exhaust to finish tomorrow and it will run.

Congrats bro!!!

Congrats on the new to you jeep. Hopefully you have a credit card with no limit lol.

Just got home from Jeep Speed Shop because I went down to pick up the motor, tranny, and transfer case because I already had them sold. Few small issues they found were 2 Evo Long arm brackets were broken and needed to be re welded, my cross member was so bent they have to replace it to bolt the...