Search results

  1. 2

    Axle seals AB/AC

    Ok .. We know jeep changed axle shafts in 2013. I recently replaced my seals with 5014852AB seen in pic 1 One seal went in a little cocked. Worried I ordered 2 new seals. The seals I received, same part number but ending in AC. These are a 2 piece seal and show 2013+ But some have said they...
  2. 2

    Just ordered new ball joints

    Funny, we rented a press from AZ. Of coarse it was missing the ever so important angled piece. We made do cutting a piece of pipe at a angle. Couple tips :) -Start soaking your hub bolts. Wire brush the ends sticking out past the hub before running them out. -A 21mm brake bolt works prefect...
  3. 2

    Tea, Crumpets, and JK Dual Steering Stabilizers

    Here's mine at 3.5 The track bar should disappear behind the drag link looking from the front.
  4. 2

    Tea, Crumpets, and JK Dual Steering Stabilizers

    Draw a line from mounting point to mounting point like this.
  5. 2

    disconnecting sway bar on stock jk

    Here you go
  6. 2

    Manual Locking Hubs: Locked or Unlocked During Everyday Use

    I thought one of the benefits is running more caster/ DS angle and not have to worry about failure/vibes.
  7. 2

    What was done to your rig this week?

    Stripped down for axle seal and a u-joint. Debating if I should just replace the bearings (60k) ? Zoom in ... The seal is split :(
  8. 2

    Front axle leaking diff fluid?

    Went for it today. Unfortunately I have the old shafts. Thanks for the write-up ... I followed.
  9. 2

    Front axle leaking diff fluid?

    I'm seeing 2 different part #'s on seals. I have the 1 piece seal. Crown showing for TJ/Jk 44 (5014852AB) The other is a 2 piece seal but 2013 + (5014852AC) I'm assuming the shaft diameter is bigger 2013+ Unless there's something else I'm not aware of ??
  10. 2

    2007blackJk - I'm not known for starting shit on any forum

    Ugh...........,,
  11. 2

    rear teraflex track bar bracket

    Your axle will rotate up and pull in slightly with lift height. lower arms set axle position and uppers set pinion angle. Installing CA's with a proper pinion angle is only going to make things worse. Check out coil correction wedges mentioned. I believe JKS offers bolt on coil buckets also...
  12. 2

    Enforcers Unite!

    Nice .. How much height did you get with the evo 3" coils. Use this to compare In the rear .. Measure from the bumpstop pad to the metal cup holding the jounce bumper. Stock measures around 5" Just curious ... Ty
  13. 2

    Sway Bar Quick Disconnect

    A friends we did up.
  14. 2

    Impact wrench

    1/2 HF Earthquake. 3 years, a good amount of use. Love it !!!
  15. 2

    Dynomax exhaust

    Finished up. Sounds good. Not too loud. The tires still bury out everything lol. Track bar clearance is not looking heathy.
  16. 2

    Hello

    Names Ken from CT Owned 3 jeeps 1992, a 2001 and now a 2007 2 door. 92 and 01 pretty much stayed stock. 2007 is a WIP. Lifted 3.5" on 35's.
View older results
Top Bottom