Disciple Off Road's latest activity

Figure out if it's the front or rear, as Mike stated, the sensors are not potted and over time oil seeps in and causes them to fail...

You guys need a road trip to test it out! Redding is nice this time of year. 😃

It does, unfortunately. Robyn and I were on the way to Montana to see Alex and got the error just driving up the highway.

Could be that too, just couldn’t remember if that fully disables 4WD.

Sounds like an issue with the FAD (front axle disconnect). Check the plug and wires. If you had a lift recently installed, the wires...

Ok thanks, that answers what I was curious about. Yes, I had read that the bearing caps tended to rub but these didn't. I did go ahead...

I've never used a spreader and do it by feel but, you should have to tap in the shims. You can get a good feel for preload as well when...

I need to start proof reading before I hit send, starting to sound like Bob

Starting depth is usually .042 on the JK is usually a good starting point and going up from there. I’d actually just try getting closer...

How are you applying pressure/resistance to the carrier when checking for pattern? It looks like you’re getting sufficient resistance...

Been talking to Mel over at EVO about him finally making the move to Arizona next month and that got me thinking, who's left? Literally...